how to install Self Adhesive Vinyl Flooring


New member
Mar 12, 2019
Self adhesive vinyl marble flooring
◆ Ultra-light and ultra-thin Plates are generally only l-2mm thick, only 2-5kg per square meter, less than 10% of ordinary floor materials. In the high-rise buildings, there is an unparalleled advantage for building weight and space savings. At the same time, it has a special advantage in the renovation of old buildings.
◆Abrasion and pressure resistance The surface of PVC floor has a special high-tech processed transparent wear layer. And it has the characteristics of wear resistance.
◆Slip-proof and odor-free The wear-resistant layer on the surface of PVC floor has special anti-slip property, and the surface has a layer of concave and convex anti-skid lines clearly visible.
◆ Fire-retardant fire-resistant PVC floor fire-proof index can reach Grade B, second only to stone
Self adhesive vinyl marble flooring installation method
1. Start with a sharp angled corner, first stick along the wall that is perpendicular to the exterior wall. If there is a need for trimming, look at the situation, sometimes you can use the knife of the paper cutter to fold the excess part into a right angle and stick it to the foot line. More complicated corners need to be cut. When you paste it, first clean the floor with a floorboard, or use a dry towel to wipe the floor and foot line. Avoid dirty things under the floor, affecting the flatness.
2. After installing a wall edge (the edge is not processed by the whole block), another vertical wall edge is installed from the corner. After installing two adjacent wall edges in this way, it can be attached simultaneously in both the horizontal and vertical directions, and the two people will have higher efficiency at the same time. However, the two stickers may be different due to the strength of the hand, resulting in inconsistent deviation sizes, resulting in more and more errors. Try to align the edges every time. Use a ruler to help align. Avoiding larger and larger errors leads to the need to cut one edge or corner of a certain floor. When sticking, first diagonally, then to the side, then lay the whole floor down and compact. If it is not right, you can re-attach it and repost it. When uncovering, use the protective paper pad on the back of the torn floorboard on the hand (note that the side that is in contact with the backing of the floor (wax side) is in contact with the adhesive) to avoid finger contact with the glue, which is beneficial for operation. It also avoids contamination of the glue resulting in a decrease in viscosity. When you uncover it, you should uncover it a little bit. You can't lift it and avoid breaking the floor. (If it is just a crease, it usually does not affect the use).how to install Self Adhesive Vinyl Flooring

Promote Your Website!
1:1 Banner Exchange | Advertise